丁香实验_LOGO
登录
提问
我要登录
|免费注册
点赞
收藏
wx-share
分享

Maxam-Gilbert Sequencing

互联网

2469

A modified, abbreviated version of the Maxam-Gilbert sequencing is described. A complete description including the methods to prepare and isolate asymmetrically labeled fragments of DNA and to prepare and run sequencing gels can be found in Methods in Enzymology 65: 497-559.

Reagents:

-Dimethylsulfate (DMS) Extremely dangerous.

-Hydrazine (HZ) Very dangerous.

-Formic acid

-Piperidine. Stock is 10 M. Dilute to 1.0 M just before use.

-100% Ethanol

-dH2O

-Acetic Acid. Glacial is 17.4 M. Dilute to 1 M.

-0.3 M Sodium acetate (pH 5.2)

-5 M NaCl

-10 N NaOH

-500 mM EDTA

-tRNA. Stock solution is 1mg/ml in dH2O.

-Calf thymus DNA. Stock solution is 1 mg/ml in TE.

Buffers:

DMS buffer

50 mM sodium cacodylate (pH 8.0)

1 mM EDTA

DMS stop

1.5 M sodium acetate (pH 7.0)

1.0 M mercaptoethanol

100 μg/ml tRNA

HZ Stop

0.3 M sodium acetate

0.1 M EDTA

25 μg/ml tRNA

Loading buffer

80% (v/v) formamide

50 mM Tris-borate (pH 8.3)

1 mM EDTA

0.1% (w/v) xylene cyanol

0.1% (w/v) bromophenol blue.


Hints:

1. 200 cps per 5 μl reaction or greater is recommended.

2. -70℃ incubations can be done on powdered dry ice.

3. 30 minute 90℃ incubation should be done with a device which holds Eppendorfs closed.

4. During multiple ethanol precipitations monitor presence of pellet with Geiger counter.

Nucleotide sequencing gels:

All gels are pre-run at 1200 volts for 30' (do not go longer on 20% gels)

Nucleotides 1-50

Use a 20% gel,

Run BPB to 15cm for nucleotide 1 on bottom. Alternatively, for a better spread, run BPB to 20cm for nucleotide 3 on bottom. To do this, run the gel at no more than 28 milliamps, 2000-2500 volts.

At 2000 volts, this takes 1 1/4 hours.

Nucleotides 40-150

Use an 8% gel.

Run XC to 27 cm. To do this, run the gel at no more than 28 milliamps. Voltage should start at

about 1500 volts and drops during run as plates heat up.

The run should take 3 - 3 1/2 hours.

Nucleotides 140-?

Use an 8% gel.

Run XC to 2 gel lengths (72 cm). Re-load dyes when XC is at 36 cm. To do this, run the gel at

no more than 28 milliamps. Voltage should start at about 1500 volts and drops during run.

The run should take 7 - 8 hours.

提问
扫一扫
丁香实验小程序二维码
实验小助手
丁香实验公众号二维码
扫码领资料
反馈
TOP
打开小程序