丁香实验_LOGO
登录
提问
我要登录
|免费注册
点赞
收藏
wx-share
分享

DIRECT ELISA USING FLUORESCENT SUBSTRATE PROTOCOL

互联网

847

Day 1:
1. Coat with 100 μl/well of coating antibody diluted in filtered PBS. Incubate plate overnight at 4°C, covered
with plate sealer.
Day 2:
2. Block plates with 200 μl/well of 4 g Block ACE powder, diluted in 100 ml of deionized water (USE a 1:4
dilution of this) for 3 hrs at RT covered with plate sealer.
3. Wash plates: PBS-T (0.05% Tween20) 250 μl/well; 3x 30 seconds.
4. Load 100 μl of standards or samples ** freshly diluted in 10% BlockACE in PBS-T overnight at 4°C,
covered with plate sealer.
Day 3:
5. Incubate 100 μl/well of biotinylated reporter antibody diluted in PBS for 2 hours at RT covered with plate
sealer
6. Incubate 100 μl/well of streptavidin alkaline phosphatase, 1:5000 dilution in PBS for 1 hour at RT,
covered with plate sealer.
7. Wash plates: TBS 250 μl/well; 3x 30 seconds.
8. Amplify signal by adding 100 μl/well AttoPhos Fluorescent substrate system, for 5-10 min at RT. 36 mg of
AttoPhos substrate should be mixed with 60 ml of AttoPhos buffer 24 hours prior to use. Make sure well is
clean-no contamination.
9. Signal measured on Fluorometer, (Victor2, Perkin Elmer); excitation: 440 nm; emission: 550 nm
• On day of application to the plate, (day 2 in above procedures), standards are freshly diluted in 10% BSA
in PBS-T from 10 ng/ml to 500 pg/ml, for example.
• After washing or aspirating flip plate over onto kim wipes on bench to remove excess liquid.

<center> <p> </p></center>


上一篇:DIRECT ELISA PROTOCOL 下一篇:DETECTION OF RECOMBINANT PROTEINS BY ELISA

提问
扫一扫
丁香实验小程序二维码
实验小助手
丁香实验公众号二维码
扫码领资料
反馈
TOP
打开小程序