丁香实验_LOGO
登录
提问
我要登录
|免费注册
点赞
收藏
wx-share
分享

Human Embryonic Stem (ES) Cell Protocols――Embryonic Bodies

互联网

484

 


  • Let human ES cells grow until the colonies are large and the cells are pretty piled up - about the time when you would normally split or even a day past that.
  • Treat cells with 0.2 - 0.5 mg/ml dispase. You want to use the lowest possible concentration of dispase, but it tends to vary a bit.
  • Wait until the colonies completely detach from the plate. Do not blow colonies off with a pipet. This should take about 20-30 min. If nothing is happening by that point, add more dispase.
  • Once the colonies come up, gently transfer them to a 15 ml conical tube with a 10ml pipet. You don't want to break up the colonies.
  • The cells should sink to the bottom of the tube after a minute or two without any spinning. Aspirate off the media and wash once in hES media. If you are in a hurry and need to spin the colonies down, 1 min at 500 rpm is enough.
  • Transfer cells to a flask containing ES media without bFGF. Put all of the EBs from one 6-well plate into a T80 flask with about 25 mls media.
  • The cells will round up into actual embryoid bodies after about 12-24 hrs. They should then be fed every day by exchanging half the media with fresh media. The EBs should not attach, if they do, gently tap the flask to dislodge the EBs.
  •  

    提问
    扫一扫
    丁香实验小程序二维码
    实验小助手
    丁香实验公众号二维码
    扫码领资料
    反馈
    TOP
    打开小程序