MONOCOT DNA ISOLATION

互联网2013-09-06

1382

Collect fresh tissue and store at -20°C.
Grind leaf tissue to a fine powder with liquid nitrogen in a prechilled mortar [Store mortar and pestle at -20°C or -80°C].
Transfer ground tissue with a chilled paintbrush into a well-chilled, 50-ml polypropylene tube and store at -20°C. Do not let the powder thaw. All tools should be chilled in liquid nitrogen.

Add sodium bisulfite to the extraction buffer and adjust pH with 5N NaOH to 7.8�8.0. Heat the extraction buffer to 65°C and add 15�20 ml to 10�15 ml of frozen tissue. Mix well.

**DNA extraction buffer**
	for 1 L	[Final]
5M NaCl	100.0 mL	500 mM
1M Tris-HCl pH 8.0	100.0 mL	100 mM
0.5M EDTA pH 8.0	100.0 mL	50 mM
20% SDS	62.5 mL	0.84% (w/v)
Bring to final volume with sterile distilled water. Note: Add 0.38 g sodium bisulfite/100 mL extraction buffer just before use and readjust pH to 7.8�8.0 with 5N NaOH.

Incubate in a 65°C water bath for 30 min; invert the tubes every 5�10 minutes.
Add chloroform:isoamyl alcohol [24:1 v/v] to the top of the tube and mix vigorously.
Centrifuge 15 min at 4,500 rpm. Transfer upper phase into a new 50-ml tube by pouring through 2�4 layers of cheesecloth or pipette off the upper phase if the interphase does not appear solid.
Add 2 volumes (fill tube to top) of cold [-20°C] 95% EtOH and mix gently to precipitate the DNA. Place at -20°C for 30�60 min.
Pour off the 95% EtOH, wash with fresh 70% EtOH, and add 30 ml of cold 70% EtOH. Mix gently for a few minutes. DNA can be left indefinitely in 70% EtOH [can leave overnight at -20°C].
Rewash with fresh 70% EtOH if the DNA is still discolored. Remove DNA by hooking it on a Pasteur pipette and blot off excess 70% EtOH with a Kimwipe. Transfer DNA to the bottom of a sterile 1.5-ml microfuge tube. If making many extractions, centrifuge wet DNA gently, then invert tube a few minutes to let the liquid drain out. Dry DNA at RT for 2�3 hours.
Dissolve DNA in sterile TE [0.5�1 mL depending on pellet size]. Incubate in a 65°C water bath until dissolved with gentle inversion every 30 to 60 minutes or until DNA is dissolved [may take several hours].
Centrifuge 10 minutes in microcentrifuge at 13,000 rpm to remove any material that does not go into solution.
Determine the DNA concentration by separating a 1:20 dilution [1 DNA:20 TE:1 loading buffer solution] on an agarose gel along with markers (uncut lambda DNA at concentrations of 10, 20, 50, and 80 ng). Stain gel with 0.5 μg/ml of ethidium bromide for 15 minutes and photograph. Visually compare the intensity of the DNA bands with the markers to determine the concentration.