Quick and Easy Isolation of Genomic DNA from Yeast

 

Procedure

1. Transfer 1.5 ml of liquid culture of yeast grown for 20 - 24 h at 30°C in YPD (1% yeast extract, 2% peptone, 2% dextrose) into a microcentrifuge tube. Pellet cells by centrifugation at 20,000 × g for 1-5 minutes.
2. Add 200 µl of Harju- buffer
3. Immerse tubes in a dry ice-ethanol bath for 2 minutes,
4. Transfer to in a 95°C water bath for 1 minute.
5. Repeat the last two steps
6. Vortex 30 seconds.
7. Add 200 µl of chloroform and vortex 2 minutes.
8. Centrifuge 3 minutes at room temperature, 20,000 × g.
9. Transfer the upper aqueous phase to a microcentrifuge tube containing 400 µl ice-cold 100% ethanol. Mix by inversion or gentle vortexing.
10. Incubate at room temperature, 5 minutes. Alternatively, precipitate DNA at -20°C to increase yield.
11. Centrifuge 5 minutes at room temperature, 20,000 × g.
12. Remove the supernatant with a pulled Pasteur pipette by vacuum aspiration.
13. Wash the pellet with 0.5 ml 70% ethanol
14. Centrifuge 5 minutes at room temperature, 20,000 × g.
15. Remove supernatant.
16. Air-dry the pellets at room temperature or for 5 minutes at 60°C in a vacuum dryer.
17. Resuspend in 25- 50 µl TE (pH 8.0)] or water. Samples obtained directly from plates should be resuspended in a 10 µl volume, because the yield will be smaller. 0.25 µl RNase cocktail should be added to the samples used for Southern blot hybridization (final concentration 0.125 U RNAse A, 5 U RNase T1).

Reagents

Harju- Buffer
� 2% Triton X-100
� 1% SDS,
� 100 mM NaCl
� 10 mM Tris-HCl, pH 8.0,
� 1 mM EDTA