丁香实验_LOGO
登录
提问
我要登录
|免费注册
点赞
收藏
wx-share
分享

electrophoresis of DNA

互联网

515

electrophoresis of DNA



Agarose Gel Electroporesis of DNA

   
Making the gel:

1.  Place casting platform with well former sideways in gel stand where you wish to 
 pour  the gel (preferably in the 4'C cold room).
2. For a 1.2% gel, add 1.2g high purity, wide range Agarose per 100 ml to be made.
3.  Add 100 ml of 0.5X TBE (for small gels) or 200 ml of 0.5X TBE (for large gels) 
 into 250ml  bottle used and labeled for "DNA gels".
4.  Mix by swirling with the cap on, then loosen cap! and microwave for 
 about 2-3  minutes.  Stop and mix the solution once or twice during the micro waving.
5. Add 0.5 ug of Ethidium Bromide/ml of gel solution from stock solution (10mg/ml).
  Thus add 5 ul of stock solution/100ml of gel solution.
6. Pour hot gel into gel cast on a flat surface avoiding bubbles. 
7. When gel solidifies, turn gel and tray to proper position and fill gel stand with 
 0.5X TBE so that it covers gel completely.

Loading the Gel:

Mix the reaction volumes on a piece of parafilm as follows:
1. First, load appropriate volumes of ddH2O and Loading Dye onto parafilm 
 (see mixture volumes below):
2. One sample at a time, add the appropriate volume of sample and mix with one pipet.
3. Then, with the same pipet tip, load the sample with the loading pipet 
 (one with red  tape) into the appropriate well very carefully. 
4. Write down what samples are in each well.

Mixture volumes (for a total of 12 ul):

  Standard DNA mixtures: Fragment mixture:
  Standard DNA 2.0 ul PCR product 5.0 ul 
  ddH2O  8.0 ul  ddH2O 5.0 ul              
  Loading dye  2.0 ul Loading dye 2.0 ul    


Running the gel:

Note: DNA and RNA are negatively charges and thus run from positive to negative 
or from the black to red side if hooked up properly.

1. Add 3-4 ul of Ethidium Bromide stock solution to the bottom of the gel box 
on the side nearest you (red, positive side).
2. Place lid over apparatus with black lead on the side with the wells.
3. Run gel at 80V for 1-4 hours depending on the size of the DNA 
(larger DNA runs more  slowly than smaller DNA).

 

提问
扫一扫
丁香实验小程序二维码
实验小助手
丁香实验公众号二维码
关注公众号
反馈
TOP
打开小程序