丁香实验_LOGO
登录
提问
我要登录
|免费注册
点赞
收藏
wx-share
分享

Prehybridization and probe labeling

互联网

698

 

Prehybridization

  1. Set hybridization oven to 65°C.
  2. Thaw 32 P isotope in hood.
  3. Place membrane in hybridization tube.
  4. Add 50 mL of prehybridization buffer to each tube.
    Prehybridization buffer [for 4 probes]
    ddH2 0
    125 mL
    20X SSPE
    60 mL
    100X Denhardt's solution
    10 mL
    20% SDS
    5 mL

    Salmon sperm DNA [10 mg/mL; boil for 5 minutes and set on ice 5 minutes before adding]

    1 mL
    TOTAL
    200 mL
  5. Prehybridize membranes for at least 6 hours to overnight.

Probe labeling

  1. Heat water to boiling in a beaker on a hot plate.
  2. Labeling components are
    Labeling components
    DNA
    1.0 µL [20�50 ng]
    ddH2 0
    4.0 µL [total volume of H2 0 and probe = 5 µL]
    Oligo primers
    1.0 µL
    dNTPs [5 mM]
    1.5µL

    Klenow polymerase

    1.0 µL
    10X Klenow buffer
    1.5µL
    dCTP 32 P
    5.0 µL
    TOTAL
    15.0 µL
  3. Conbine ddH2 0, oligo primer, and DNA in a 1.5-ml microfuge tube, boil for 4 minutes, and place on ice.
  4. Add dNTPs, 10X buffer, Klenow enzyme, and 32 P. Mix, spin briefly, and allow reaction to go overnight at room temperature or place at 37°C for 2 hours.

Column preparation

  1. Add glass wool to the base of a 1-mL syringe and place in a 15-mL centrifuge tube.
  2. Using a transfer pipet, fill the syringe with a solution of Sephadex G-50 in TE. Avoid getting air bubbles in the column.
  3. Centrifuge tubes for ~30 seconds, refill tubes with fresh Sephadex G-50 solution, and centrifuge at 1,500 RPM for 4 minutes.
  4. Add 200 µL of TE to each column and centrifuge for 4 minutes at 1,500 RPM.

Probe purification

  1. Add 185 µL of TE to each probe.
  2. Cut the cap off the tube and withdraw all of the probe solution from the tube with a pipet. Place an empty tube under the syringe and add the probe to the top of the column.
  3. Spin the column for 4 minutes at 1,500 RPM.
  4. Discard the column; remove tube with pruified probe and recap.
  5. Add a cap-lock to the tube, boil for 4 minutes, and place on ice.

 

提问
扫一扫
丁香实验小程序二维码
实验小助手
丁香实验公众号二维码
扫码领资料
反馈
TOP
打开小程序