CELL CYCLE ANALYSIS

PROPIDIUM IODIDE: The most commonly used dye for DNA content/cell cycle analysis is PROPIDIUM IODIDE (PI). It can be used to stain whole cells or isolated nuclei. The PI intercalates into the major groove of double-stranded DNA and produces a highly fluorescent adduct that can be excited at 488 nm with a broad emission centred around 600 nm. Since PI can also bind to double-stranded RNA, it is necessary to treat the cells with RNase for optimal DNA resolution. The excitation of PI at 488 nm facilitates its use on the benchtop cytomters. However, PI can also be excited in the U.V. (351-364 nm line from the argon laser) which should be considered when performing multicolour analysis on the multibeam cell sorters

Protocol for staining whole cells with PI:

1. Harvest cells and prepare single cell suspension in buffer (e.g. PBS + 2% FBS; PBS + 0.1% BSA)
2. Wash cells X2 and resuspend at 1-2 x 106 cells/ml.
3. Aliquot 1 ml cells in a 15 ml polypropylene, V-bottomed tube and add 3 ml cold absolute ethanol. (The ethanol can be added forcibly by expelling from a pipette or dropwise while vortexingdetermine the best method for each cell type to prevent clumping and cell loss.)
4. Fix cells for at least 1 hour at 4oC. (Cells may be stored in 70 % ethanol at -20 oC for several weeks prior to PI staining and flow cytometric analysis).
5. Wash cells X2 in PBS. (It may be necessary to centrifuge cells at a slightly higher "g" to pellet after ethanol fixation as the cells become floculent.)
6. Add 1 ml of propidium iodide staining solution to cell pellet and mix well. Add 50 ul of RNase A stock solution and incubate 3 hr at 4oC.
7. Store samples at 4oC until analysed by flow cytometry.

ACRIDINE ORANGE: Differential Staining of DNA/RNA with ACRIDINE ORANGE (AO) can be performed for simultaneous assessment of DNA and RNA content of cells. The AO exhibits different spectral characteristics when bound to DNA or RNA that can be excited at 488 nm with either a GREEN or RED fluorescence respectively.

Protocol for staining whole cells with AO:

1. Wash cells X2 in buffer (e.g. PBS + 2% FBS; PBS + 0.1% BSA).
2. Resuspend cells to 1 x 106 cells/ml in buffer.
3. Add 200 ml to a clean test tube and add 400 ml of Solution A. Mix gently by swirling tube.(DO NOT VORTEX).
4. Stand for 15 seconds and then add 1.2 ml of ice-cold Solution B.
5. Stand on ice for 5 to 15 min to allow sample to equilibrate and analyze for fluorescence immediately.

HOECHST: The Hoechst dyes 33342 and 33258 are bis-benzimide derivatives. They can be used for cell cycle analysis of viable cells and can be used at low concentrations limiting toxicity problems. The Hoechst dyes bind to AT-rich regions of the DNA and when excited with a U.V. source (e.g. . (351-364 nm line from the argon laser) produce bright fluorescence at 465 nm. DAPI (diamidino-2-phenylindole 2HCl) is also an AT binder with similar spectral properties to the Hoechst dyes.

Protocol for staining whole cells with HOECHST:

1.Wash cells X2 in buffer (e.g. PBS + 2% FBS; PBS + 0.1% BSA).
2. Resuspend cells to 1 x 106 cells/ml in buffer.
3. Add an equal volume of Hoechst dye (working solution 5 mM).
4. Incubate for 15 min at 37oC.
5. Analyse for fluorescence or cells can be washed and fixed in paraformaldehyde (1% in PBS) for future analysis